5 Series E60 M5 (S85) SAL
37 15 055
Removing and installing/replacing EDC
control unit (M model)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove trim for instrument panel, bottom left
•
Remove footwell side trim panel on A-pillar, right
Press floor trim at front right to one side.
Open cutout in insulating mat (shown with dotted line) and release
nut (1).
Disconnect connector (2).
Unclip clip (3).
Slide control unit (4) with bracket upwards and remove sideways.
If necessary, remove control unit (4) from bracket.
After installation:
•
Carry out programming/coding
RA Removing and installing/replacing EDC control unit (M model)
BMW AG - TIS
22.02.2013 22:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -