bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing (replacing) Battery (M5)|Page 2267 > < 1 RA Performing Battery _power Reset_ (for Programming_coding Control Unit(s))
Page 1
background image

61 21 010

Removing and installing (replacing) battery
(M5)

Warning!

Observe safety instructions for handling vehicle battery.

Observe notes on power supply / on intelligent battery sensor
(IBS).

Necessary preliminary tasks:

Remove luggage compartment floor trim

Disconnect battery negative lead (1).

Disconnect plug connection (2) of one-pin IBS cable (3).

Release nut (5) of safety battery terminal (4). Tightening
torque  61 21 1AZ

.

Important!

Do not under any circumstances pull/lever safety battery
terminal (4) off by force.

Detach safety battery terminal (4) towards top, lay to one side
and secure.

Release nuts (1) and remove retaining bar (2).

Detach vent (3) in direction of arrow.

Fold both clips (4) open.

Lift out battery (5).

Installation:

Make sure battery (5) is correctly seated in associated

mounts.

RA  Removing and installing (replacing) battery (M5)

BMW AG - TIS

23.02.2013  04:57

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Removing And Installing (replacing) Battery (M5)|Page 2267 > < 1 RA Performing Battery _power Reset_ (for Programming_coding Control Unit(s))