5 Series E61 520d (M47T2) TOUR
12 51 001
Replacing wiring harness section for engine
(M47T2)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions for disconnecting and connecting battery
Disconnect battery negative lead from battery and lay to one
side
•
Remove fresh air duct
•
Remove intake air manifold
•
Remove intake duct
•
Remove rear underbody protection
Unlock cover (1) with slide (3).
Unfasten screws (2).
Remove electronics box cover (1).
RA Replacing wiring harness section for engine (M47T2)
BMW AG - TIS
25.01.2013 19:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
