5 Series E61 520d (M47T2) TOUR
Unlock and disconnect plug (1), unlock counterpiece and pull in
direction of arrow out of holder.
Release control sensor (1) with special tool 11 7 030 .
Installation:
Threads of new oxygen sensors are already coated with
Never Seez Compound.
If an oxygen sensor is reused, only apply a thin and uniform
coat of Never Seez Compound (refer to BMW Parts
Service) to thread.
Oxygen sensor section projecting into exhaust system branch
must not be cleaned or come into contact with lubricant.
Pay attention to cable routing of oxygen sensors.
Use special tool 11 7 030 to tighten down oxygen sensor.
Tightening torque 11 78 1AZ
.
Cover oxygen sensors when applying underseal.
Installation:
Check stored fault messages.
Now clear the fault memory.
RA Replacing control sensor (M47T2)
BMW AG - TIS
25.01.2013 19:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -