5 Series E61 520d (M47T2) TOUR
Open weld joints in areas (1).
Open brazed joints in areas (2).
Note:
Following work steps apply to M5 only.
Preparation of new part:
Rear side panel must be trimmed.
1 = Body outer side
Mark severance cut (1) in accordance with measurement and
cut.
Measurement a = approx. 30 mm.
Measurement b = approx. 50 mm
Important!
Distance to outer edge (3) is 3 mm in area (2).
The trim must have a radius of approx. 4 mm in area (2).
Otherwise there is a risk that the metal plate of the rear side
panel will begin breaking!
RA Replacing rear left side panel (partial replacement before longitudinal member c
BMW AG - TIS
26.01.2013 02:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -