5 Series E61 520d (M47T2) TOUR
64 12 ...
Initializing Telestart hand transmitter (T93)
(from build date 03/2007)
Note:
The Telestart hand transmitter must be initialized when:
•
Hand transmitter is replaced
•
Car Access System control unit is replaced
The independent heating is switched on under an outside
temperature of approx. 15
°
C with the hand transmitter and at a
preselected switch-on time.
Direct activation is possible at any outside temperature via the
"Climate" menu item in the i-Drive, but not in driving mode.
To initialize a new hand transmitter, perform the following
operations from inside the vehicle:
•
Close all doors on vehicle (vehicle must be unlocked!)
•
Within 5 seconds: Turn ignition lock from terminal "0" to
terminal "R" and then back to terminal "0" (by inserting and
removing key, insertion duration: 1 to 5 secs.)
•
Press OFF button (2) and hold down for max. 15 secs.
•
During this period of 15 secs., press ON button (1)
three
times within 10 secs.
•
Release both buttons. LED (3) on hand transmitter flashes
for approx.10 secs.
Note:
The vehicle's central locking closes and opens automatically on
successful initialization.
The initialization process must be repeated if there is no
checkback signal from the central locking system.
Important!
The initialization is lost if a valid key is inserted during
initialization!
RA Initializing Telestart hand transmitter (T93) (from build date 03/2007)
BMW AG - TIS
26.01.2013 10:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
