5 Series E61 520d (N47) TOUR
12 51 001
Replacing wiring harness section for engine
(N47, N47S)
Read out fault memory of DDE control unit. Switch off
ignition.
Observe instructions for disconnecting and connecting
battery.
Refer to general information in MG 12 .
Disconnect and cover battery negative lead.
.
Remove engine underguard.
Remove microfilter housing
Remove acoustic cover
E83 electronics box connections, see: Remove control unit
Overview, engine wiring harness
Note:
For a better overview, the plug-in contacts are shown on the
removed engine in the repair instruction.
Unlock fasteners (1) from below and slide upwards approx.
10 mm. Unlock locks (2) in direction of arrow. Remove cover (3).
RA Replacing wiring harness section for engine (N47, N47S)
BMW AG - TIS
30.01.2013 05:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
