5 Series E61 525d (M57T2) TOUR
Release and remove bearing pins (1) in direction of arrow.
Lift out shift arm (1).
Installation:
Grease bearing pins (1).
Grease,
refer to BMW Service Operating Fluids.
Release screws.
Tightening torque 23 00 1AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
RA Removing and installing transmission (GS6-53DZ) (M57T2)
BMW AG - TIS
09.02.2013 18:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
