5 Series E61 525d (M57TU) TOUR
37 10 001
Initial operation with test run of Dynamic
Drive
Note:
The Service function Initial operation of Dynamic Drive must be
carried out after:
•
Work on the Dynamic Drive system which involved opening
hydraulic lines
•
Replacement / Programming / Coding Dynamic Drive control
unit
•
Replacement lateral acceleration sensor
•
Parameters and zero point of new sensors have been
learned
Bleeding power steering:
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Using contaminated equipment to add fluid may introduce dirt
particles into the fluid reservoir and significantly reduce the
service life of the power steering system. Do not use any filler
funnels or similar!
Use only Pentosin CHF11S from original containers!
The fill level may only be checked or adjusted when the
engine is stopped! The fluid temperature should be approx.
20
°
C here.
Ensure that the cap is fully screwed in prior to the fill level
check.
Note:
To avoid mix-ups when filling with hydraulic fluid, mark the fluid
reservoirs or their caps with identification marks.
CHF Pentosin CHF11S
RA Initial operation with test run of Dynamic Drive
BMW AG - TIS
11.02.2013 13:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
