5 Series E61 525i (N53) TOUR
Secure oil pump sprocket with steel pin
∅
6 mm (3) to oil
pump.
Tighten bolt (2).
Tightening torque: 11 41 5AZ
.
Tighten down special tool 11 5 200 with screws (1) to hub.
Do not remove special tools 11 0 300 and 11 4 280 .
Tighten central bolt to jointing torque.
Tightening torque: 11 21 1AZ
.
Apply stroke of paint (1) for torsion angle tightening to tool.
See illustration.
Important!
Do not remove tool from central bolt during torsion angle
tightening - risk of damage.
Installation:
Replace radial seal at front.
Assemble engine.
RA Removing and installing or replacing chain module for oil pump/vacuum pump (N53)
BMW AG - TIS
17.02.2013 18:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -