5 Series E61 525xi (N52) TOUR
Adjusting camber:
If necessary, remove protective cap.
Knock out centering pin (1) in downwards direction.
Clean wheel arch from below in area of support bearing with
compressed air.
Slacken nut (2) approx. 1 to 1.5 turns.
Insert special tool 32 3 190 into wheel arch opening and over
nut.
Replace nuts (3) and screw on but do not tighten down fully.
Turn nut (4) in special tool 32 3 190 to adjust camber to
specified value.
Tighten down nuts (3).
Tightening torque 31 31 1AZ
.
Remove special tool 32 3 190 .
Replace nut (2) and tighten down.
Tightening torque 31 31 1AZ
.
After installation:
•
Check directional stability of car; if necessary, repeat toe-in
adjustment
RA Adjusting toe-in and camber on front axle (AWD)
BMW AG - TIS
18.02.2013 00:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -