5 Series E61 530i (N52K) TOUR
51 00 ...
Notes on bonding/attaching components with double-sided adhesive tape
1.
General notes
-
Bonding at room and object temperature of 18 to 25
°
C.
-
Newly painted parts may only be bonded after a drying time of at least 24 hours.
-
Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. Components
must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).
-
Do not touch bonding area.
-
It is not the length of time that pressure is applied but rather the level of pressure applied that is crucial.
-
Detaching the adhesive tape after pressing destroys the adhesive layer.
-
After being pressed on gently, adhesive tape can be pulled off again up to 3 times.
2.
Auxiliary materials and tools
-
Spirit, adhesive remover (sourcing reference: BMW Parts Service)
-
Fluff-free cleaning cloths
-
Pressure roller
3.
Preparations
-
Remove all remnants of adhesive or clean new part thoroughly
-
Clean the areas to be bonded immediately before bonding to remove silicone and grease residues.
Note:
Observe ventilation time
≥
1 minute.
4.
Bonding
4.1 Components without pre-fitted adhesive tape
-
Pull off liner* from adhesive tape
-
Position adhesive tape on component and stick on
-
Press down adhesive tape over entire bonding area
-
Continue with Point 4.2
* Liner is the protective film on the adhesive tape
4.2 Components with pre-fitted adhesive tape
-
Pull off liner* from adhesive side (if bonding area is large, do not pull off liner completely)
-
Align component in correct position on vehicle
-
Press down component over entire bonding area
* Liner is the protective film on the adhesive tape
RA Notes on bonding/attaching components with double-sided adhesive tape
BMW AG - TIS
18.02.2013 17:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -