5 Series E61 535xi (N54) TOUR
Release screws (1).
Disconnect connector (2).
Steel screws, tightening torque 24 00 1AZ
.
Aluminium screws, tightening torque 24 00 2AZ
.
Release aluminium screws with special tool 00 9 010 .
Note:
Illustration similar
Unclip cable (1) from holder.
Release screw (2) and remove holder (3).
Release screws (1).
Remove holder (2).
Tightening torque, 24 00 1AZ
.
Note:
Version 2
Unfasten nut.
Disconnect cable (1)
Installation:
Unfasten nut.
Adjust cable by means of holder (2) until spacing A = 1 mm is
obtained
Tighten nut.
RA Removing and installing automatic transmission (6HP19Z AWD) N54
BMW AG - TIS
19.02.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
