6 Series 630i (N52) Coupe
Detach plug (4) from clutch travel sensor.
Detach plug (1) from sensor.
Unfasten screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws 23 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws 23 00 2AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate.
Screw down aluminium screws according to angle of rotation.
Angle of rotation 23 00 2AZ
.
RA Removing and installing transmission (GS6S37BZ SMG) N52
BMW AG - TIS
15.01.2013 13:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
