6 Series 630i (N52) Coupe
Release screw (1).
Slacken screws (2)
Installation:
Tightening torque 65 77 5AZ
.
Raise B-pillar sensor (3) slightly through opening in B-pillar and
feed out towards rear.
If necessary, unclip cable duct (4).
Unlock plug connections (1) and disconnect.
Remove B-pillar sensor (2).
Installation:
Clips (3) of cable duct (4) must not be damaged.
Installation:
Make sure metal nut (1) is correctly positioned on B-pillar
sensor (2).
Replacement:
Carry out programming/coding.
RA Removing and installing (replacing) left B-pillar sensor
BMW AG - TIS
15.01.2013 21:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -