6 Series 630i (N53) Coupe
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove underbody protection and bracket at front and rear.
•
Remove reinforcement plate.
Important notes on installation are described in this work
step.
•
Remove complete exhaust system.
Remove heat shields (1) and (2).
Disconnect plug connector (1).
Release screws (2).
Remove bracket (3).
Remove holder (4).
Tightening torque 23 00 1AZ
.
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Installation:
Aluminium screws must be replaced.
Tightening torque 23 00 2AZ
.
RA Removing and installing transmission (GS6-37BZ) N53/N52K
BMW AG - TIS
17.01.2013 12:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -