6 Series 630i (N53) Coupe
64 12 ...
Initializing independent heating remote
control
The following steps are required for initializing a new independent
heating remote control or after replacing the Car Access System
control unit:
A) Close and then reopen central locking with vehicle remote
control.
B) Within 5 seconds: Switch ignition lock from terminal "0" to
terminal "R" and then back to terminal "0".
C) Press and hold down "OFF" button on independent heating
remote control.
D) Press "ON" button on independent heating remote control 3
times in succession
The vehicle's central locking closes and opens automatically on
successful initialization.
Note:
Both independent heating remote controls must be reinitialized
after the Car Access System control unit has been replaced.
RA Initializing independent heating remote control
BMW AG - TIS
17.01.2013 18:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -