6 Series 630i (N53) Coupe
67 61 007
Removing and installing/replacing drive with
gear (rear) for slide/tilt sunroof
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Detach cover for auxiliary brake light (1) on both sides in direction
of arrow and unclip at points (2).
Feed cover for auxiliary brake light (1) in direction of arrow out of
roofliner (3) and remove.
Installation:
Retaining bar (1), clips (2) and guides (3) must not be
damaged.
Make sure cover for auxiliary brake light (4) is correctly seated.
Note:
Secure drive with gear for actuating slide/tilt sunroof (3) against
falling out.
Unfasten plug connection (1) and disconnect.
Release screws (2), tightening torque 54 13 1AZ
.
Note:
Screws (1) are microencapsulated.
Feed drive with gear for actuating slide/tilt sunroof (3) out of
roofliner (4) and remove.
RA Removing and installing/replacing drive with gear (rear) for slide/tilt sunroof
BMW AG - TIS
17.01.2013 19:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
