6 Series 645Ci (N62) Coupe
11 23 010
Removing and installing/replacing vibration
damper (N62/N62TU)
Necessary preliminary tasks:
•
Remove alternator drive belt
•
Remove A/C compressor drive belt
•
Remove fan cowl
Release bolts and remove vibration damper (1).
Note:
On BMW ALPINA B7 vehicles, the additional radial compressor
belt pulley must be removed as well.
When replacing the bolts, bear in mind the altered bolt length in
BMW ALPINA B7 vehicles.
Installation:
Vibration damper is secured on hub with an alignment pin (4).
Installation:
Fit bore (2) in vibration damper (1) on alignment pin in hub.
Fit disk (3).
Replace screws.
Tightening torque 11 23 3AZ
.
RA Removing and installing/replacing vibration damper (N62/N62TU)
BMW AG - TIS
18.01.2013 05:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
