6 Series 645Ci (N62) Coupe
Important!
Do not mix up the camshaft bearing covers of
cylinders 1 to 4 and 5 to 8.
Note:
Bearing caps are marked as illustrated with R E2 to R E5.
Remove bearing caps R E2 to R E5 and place to one side in
order.
Lift out inlet camshaft (1).
Note:
Further tasks:
The section Removing and installing left eccentric shaft contains
important installation instructions.
If necessary, replace plain compression rings (1).
Important!
Plain compression rings (1) can easily break.
Plain compression rings (1) are engaged at joint.
Press compression ring (1) on one side into groove, pull up on
other side and remove catch.
Carefully pull compression ring (1) apart and remove towards
front.
RA Removing and installing/replacing left inlet camshaft (N62 to 9/03)
BMW AG - TIS
18.01.2013 05:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -