6 Series 645Ci (N62) Coupe
Fit centring sleeves (special tool 11 9 475 ) and align special
tool 11 9 472 to bearing caps 2 and 3.
Insert special tool 11 9 474 and initially tighten without play.
Note:
Special tools 11 9 472 , 11 9 474 and 11 9 475 remain
fitted until all torsion springs and intermediate levers have been
installed.
Note:
Installation of the intermediate levers and torsion springs is
described on the 4th cylinder.
The same procedure is applicable to cylinders 1 to 3.
Attach special tool 11 9 490 to ends of torsion spring.
Install torsion spring (1).
Insert screw (1) and tighten down.
RA Removing and installing/replacing right inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
18.01.2013 05:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
