6 Series 645Ci (N62) Coupe
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Fit bearing cap L E1 in such a way that marking is legible from
inlet side.
Install nuts and tighten down.
Tightening torque 11 31 1AZ
.
Rotate inlet camshaft at hexagon head against direction of rotation
until cam on 1st cylinder points downwards at an angle as shown
in graphic.
Note:
The marking (1) on the hexagon drive of the inlet camshaft faces
upwards.
Install inlet and exhaust adjustment unit on right side.
Install spark plugs on cylinder bank 1 to 4.
Install right cylinder head cover.
Install ignition coils on cylinder bank 1 to 4.
Install servomotor for right eccentric shaft.
Assemble engine.
RA Removing and installing/replacing right inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
18.01.2013 05:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
