6 Series 645Ci (N62) Coupe
Note:
Inlet camshaft of cylinder bank 1 to 4 is marked with "EIN 14".
If necessary, replace sensor gear (1).
Release screw (2) and remove sensor gear (1).
Installation
Installation of inlet camshaft is described separately from removal.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Note:
Camshaft has a groove and sensor gear has a lug for fastening
purposes.
Fit sensor gear (1) and align to groove in camshaft.
Insert screw (2) and tighten down.
Tightening torque of screw (2) 11 31 14AZ
.
RA Removing and installing/replacing right inlet camshaft (N62 to 9/03)
BMW AG - TIS
18.01.2013 05:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
