6 Series 645Ci (N62) Coupe
Remove special tool 11 9 473 .
Remove bearing bracket (1) from special tool 11 9 470 .
Important!
Do not tilt bearing bracket (1).
Lower bearing bracket (1) from above and carefully bring into
contact with cylinder head.
Insert nuts and tighten by hand without play.
Important!
Make sure none of the intermediate levers or rocker arms
have slipped out.
Tighten down nuts from inside to outside.
Tightening torque 11 31 1AZ
.
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Fit bearing cap L E1 in such a way that marking is legible from
inlet side.
Install nuts and tighten down.
Tightening torque 11 31 1AZ
.
Rotate inlet camshaft at hexagon head against direction of rotation
until cam on 1st cylinder points downwards at an angle as shown
in illustration.
Note:
The marking (1) on the hexagon drive of the inlet camshaft faces
upwards.
RA Removing and installing/replacing rocker arms on right inlet side (N62 from 9/03
BMW AG - TIS
18.01.2013 05:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
