6 Series 645Ci (N62) Coupe
Remove sealing cap (1) using a screwdriver (2).
Service opening must not be damaged. Burr can cause the
sealing cap to leak.
Installation:
Replace sealing cap.
Release fitting screw (1).
Tightening torque 23 31 3AZ
.
Installation:
Replace fitting screw (1).
Remove screws (1) and (2).
Tightening torque 23 41 1/7AZ .
Unlock and detach hydraulic lines (3).
Pull out shift actuator (4)
Installation:
Clean sealing surfaces.
Apply Loctite 574 sealing compound to sealing faces.
Note:
After completing work:
-
Check fluid level in hydraulic system by means of DIS Tester
"Service Function"
-
Perform "Teach in transmission" service function by means
of DIS Tester
RA Replacing shift actuator GS6S53BZ SMG (transmission removed)
BMW AG - TIS
18.01.2013 07:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -