6 Series 645Ci (N62) Coupe
32 00 610
Adjusting toe-in and camber on front axle
Special tools required:
•
32 3 190
•
32 4 150
Important!
Changes in axle geometry caused by accidents must under
no circumstances be rectified by camber adjustment!
Note:
Camber and toe-in influence each other. Adjust the toe-in first in
order to simplify the adjustment procedure.
The centering pin may only be driven or twisted out if the camber
is outside the specified tolerance after toe adjustment.
Version with active front steering:
-
Align steering wheel
-
Set cumulative steering angle by means of the service
function "Carry out initial operation/adjustment for active front
steering" to "zero".
-
Install special tool 32 4 150 to secure active front steering
power steering gear.
(Refer to assembly and installation instructions).
Note: If special tool 32 4 150 cannot be installed, the
steering wheel must be secured with the steering wheel
arrester. The cumulative steering angle must remain at "zero"
during the adjustment operation.
Important!
Once the special tool 32 4 150 has been fitted, the
cumulative steering angle must still be set to "zero"!
-
Check cumulative steering angle, reposition special tool
32 4 150 if necessary.
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
18.01.2013 07:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -