6 Series 645Ci (N62) Coupe
33 32 071
Replacing one upper control arm
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
Shown on vehicle at rear right:
Unclip line for pulse generator (1) from holder (2).
Only on right side: Unclip line for brake pad wear sensor (3) from
holder (2).
Release nut (1); if necessary, grip at external hexagon/Torx
socket.
Remove control arm at top from wheel carrier.
Installation:
Keep control arm to wheel carrier connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 33 32 8AZ
.
RA Replacing one upper control arm
BMW AG - TIS
18.01.2013 08:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
