6 Series 645Ci (N62) Coupe
51 31 021
Removing and installing/replacing rubber
frame for windscreen
Important!
Rubber frame (1) features an aluminium section inlay (2).
If necessary, remove fitted spacer buffers (8).
Carefully unwind rubber frame (1) (windscreen breakage).
Note:
Tear-off lip (5) may be stuck to adhesive (4).
When rubber frame (1) is removed, tear-off lip (5) can tear off
and remain in vehicle.
3
windscreen
6
Bridge
7
Pinched butyl
Installation:
Clean cutout.
There is no tear-off lip (3) in area (A) but there is acoustic foam
fitted in the top area.
Pay attention to center marking on rubber frame (1) and
windscreen.
Replacement of rubber frame without windscreen removal:
Detach tear-off lip (4) from rubber frame (1).
If adhesive leaks over tear-off lip (4) at bridge (5), this area must
be cut out partially.
To facilitate installation, coat rubber frame (1) and body cutout
with water.
Replacement of rubber frame with removed or new windscreen:
Fit rubber frame (1) with tear-off lip (4).
2
Aluminum strip
3
Butyl
RA Removing and installing/replacing rubber frame for windscreen
BMW AG - TIS
18.01.2013 09:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
