6 Series 645Ci (N62) Coupe
64 11 274
Replacing water valve for heater
Warning!
Danger of scalding!
Only perform this work after engine has cooled down.
Necessary preliminary tasks:
•
Remove intake filter housing.
•
Disconnect coolant hoses from water hose for heater.
Unfasten plug connection (1) and disconnect.
Release spring clamps (2) and detach coolant hoses.
Pull out water valve for heater (3) towards top.
Installation:
Fill and vent cooling system.
Installation:
Make sure water valve (1) is correctly seated in grommets (2)
and rubber mount (3).
If necessary, replace grommets (2) and rubber mount (3).
RA Replacing water valve for heater
BMW AG - TIS
18.01.2013 11:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
