6 Series M6 (S85) Coupe
11 00 050
Removing and installing engine (S85)
Necessary preliminary tasks:
•
Remove underbody protection.
•
Remove both front wheels.
•
Remove fresh air duct.
•
Remove SMG transmission [23].
•
Remove front wall.
•
Remove oil filter housing.
•
Drain coolant.
•
Remove module carrier with radiator.
•
Remove expansion tank.
•
Detach coolant hose from auxiliary water pump.
•
Draw off hydraulic fluid [32].
•
Remove fluid reservoir with lines for steering gear.
•
Draw off A/C system.
•
Detach lines from A/C compressor.
•
Disconnect all plug connections in electronics box.
•
Remove both intake filter housings.
•
Remove intake air manifold.
•
Disconnect hose for crankcase ventilation.
•
Disconnect hose for suction jet pump.
•
Remove heat shield on front axle carrier.
•
Release steering spindle.
•
Remove left and right oxygen sensors.
•
Remove left and right temperature sensors [17,62].
•
Release grounding strap on engine support arm.
•
Unscrew left and right engine mounts.
•
Carefully lift out engine with two persons.
Important!
Risk of damage to steering gear and oil sump.
RA Removing and installing engine (S85)
BMW AG - TIS
19.01.2013 13:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
