6 Series M6 (S85) Coupe
Screw special tool 11 6 360 to 80 Nm into radial seal.
Release radial seal from housing.
Repeat the operation several times if necessary.
Note:
Carefully saw open old radial shaft seal with an iron saw from
special tool 11 6 360 .
Remove remnants of sealant from sealant outlet (1) on left and
right.
Apply Drei Bond sealant (refer to ETK) to sealant outlet (1) on
left and right.
Secure special tool 11 5 331 with bolts (1).
Important!
Pay attention to dowel pin.
Push special tool 11 7 231 onto special tool 11 5 331 in
direction of arrow.
RA Replacing front crankshaft radial seal (S85)
BMW AG - TIS
19.01.2013 13:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
