6 Series M6 (S85) Coupe
To slacken screw connection of actuating lever (1), grip
screw (3) and release nut (2). (Replace nuts).
Release screw connections of actuating levers of throttle valve
assemblies 1-4 and 7-10.
Adjusting a throttle valve assembly:
Move actuating lever (1) in direction of arrow, i.e. "close throttle
valve", until actuator (2) of throttle valve rests without play on
stop screw (3).
Important!
Do not exert any pressure!
Tighten down screw connection of actuating lever (1) again to
actuating shaft. Observe the following instructions in so doing:
-
Use nuts only once.
-
When pretightening screw connection (approx. 5 Nm), hold
actuating lever (1) of throttle valve in direction of arrow at
"close throttle valve".
-
Only turn nut and grip screw.
-
To screw down, use two open-end wrenches which are to be
placed at right angles to actuating shaft.
In this way, no lever action is exerted on the throttle valve
linkage; such torque would impair the quality of adjustment.
-
After pretightening actuating lever, actuate throttle valve
several times at full load.
Note:
If necessary, carry out adjustment with a second person.
RA Performing throttle valve basic setting (S85)
BMW AG - TIS
19.01.2013 13:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -