6 Series M6 (S85) Coupe
13 62 531
Replacing coolant temperature sensor (S85)
Warning!
Danger of scalding!
Only perform these tasks on an engine that has cooled down.
Necessary preliminary tasks:
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Switch off ignition
•
Remove intake air manifold
•
Release cable duct in V-chamber, unlock plug connections
and disconnect, slide cable duct to one side
Recycling
Catch and dispose of escaping coolant.
Observe country-specific waste-disposal regulations.
The coolant temperature sensor is located in the V-chamber on
the right.
Release temperature sensor (1).
Installation:
Tightening torque 13 62 3AZ
.
If necessary, top up coolant.
RA Replacing coolant temperature sensor (S85)
BMW AG - TIS
19.01.2013 13:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -