6 Series M6 (S85) Coupe
21 51 500
Removing and installing or replacing clutch
release bearing/lever (GS7S47BG SMG)
Note:
(transmission removed)
Important!
Clutch release bearing is made of aluminium and its sliding
surfaces must be covered with a thin film of grease.
Detach release bearing (1).
Installation:
Clean all sliding surfaces on clutch release bearing, check for
damage and replace if necessary.
Sliding surfaces (2) of clutch release bearing must rest on
sliding surfaces (3) of release lever.
Apply a thin coating of grease to sliding surfaces (2) of
release bearing.
Grease, refer to BMW Service Operating Fluids.
Withdraw release lever (4) from spring wire clip (5) and remove.
Installation:
Clean release lever.
RA Removing and installing or replacing clutch release bearing/lever (GS7S47BG SMG)
BMW AG - TIS
19.01.2013 14:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -