6 Series M6 (S85) Coupe
Important!
Catch hydraulic fluid from expansion tank in a suitable
container.
Release clamp (1).
Carefully detach reservoir in direction of arrow and secure or tie
up to transmission with cable tie.
Do not detach return line from reservoir.
Installation:
Replace clamp.
Replace sealing rings in expansion tank only if damaged.
Release screws (1) and remove hydraulic pump.
Important!
Risk of damage:
Only the screws identified in the picture may be released.
Failure to comply with this requirement will result in hydraulic
pump malfunction!
Installation:
-
Before installing pump, adhere to conditions of absolute
cleanliness.
-
Align drive shaft (1) of electric motor horizontally
-
Check sealing ring (2) for damage. Sealing ring may only be
replaced if damaged!
Installation:
-
Attach greased coupling element (1) from repair kit to oil
pump (2) and align horizontally to electric motor drive shaft.
Note: Hydraulic pump is relatively difficult to turn because of
the high pressure level.
-
Attach oil pump to electric motor drive shaft until it can be
heard to snap into place.
Tightening torque 23 41 30AZ
.
RA Replacing electric motor on hydraulic pump (GS7S47BG SMG)
BMW AG - TIS
19.01.2013 14:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
