6 Series M6 (S85) Coupe
32 41 332
Replacing pressure line for power steering
(S85)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove alternator drive belt
•
Remove pressure accumulator
•
Lower front axle support
Release banjo bolt (1) and detach pressure line (2) from vane
pump.
Installation:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
RA Replacing pressure line for power steering (S85)
BMW AG - TIS
19.01.2013 15:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
