6 Series M6 (S85) Coupe
34 52 525
Replacing one front pulse generator
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Note:
Read and comply with General Information.
Observe safety instructions on raising the vehicle.
Open plug housing (1), pull plug connection (2) out of bracket
and disconnect.
Pull cable with rubber grommet out of bracket on spring strut.
Installation:
Ensure proper locking of plug connector and proper seating of
rubber grommets.
Release hexagon socket head cap screw (1) and pull wheel
speed sensor out of bore.
Installation:
Tightening torque 31 51 6AZ
.
Clean bore hole for pulse generator and grease with Staburags
NBU 12/K lubricating grease (refer to BMW Service Operating
Fluids).
RA Replacing one front pulse generator
BMW AG - TIS
19.01.2013 15:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -