6 Series M6 (S85) Coupe
This mode is intended for service work
(e.g. brake dynamometer).
Note: Reactivating DSC
Briefly pressing the button again reactivates the DSC function. The DSC indicator and warning light goes out
(unless the system has developed a fault).
If the DSC button remains pressed for longer than 10 seconds (e.g. by a handbag on the centre console),
DSC will detect an operating error. The DSC function remains active and cannot be deactivated until the
ignition has been switched off and on again.
Switch-on conditions
DSC is in ready mode after each engine start.
Notes for service staff
Service staff should note the following points:
-
General information: [more ...]
-
Diagnostics: ---
-
Encoding/programming: [more ...]
-
Car & Key Memory: ---
Subject to change.
SBT Dynamic Stability Control DSC 8 E60, E61, E63, E64
BMW AG - TIS
19.01.2013 23:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -