6 Series E64 635d (M57T2) CONVER
•
Movement of the convertible top is interrupted due to a malfunction
•
Button not pressed (released) and the convertible top has not reached a secure end position
The control LED in the switch cluster centre console lights up red if the convertible top compartment is raised
and the at the same time a button (OPEN/CLOSE) is pressed.
Check-Control messages are displayed for different malfunction causes.
Check-Control messages are displayed at the same time in the instrument cluster, the central information
display and the head-up display.
Opening and closing convertible top with key; opening convertible top and windows with remote control
There are two different ways of moving the convertible top:
•
Opening and closing with the key in the driver's door lock barrel
•
Convenience opening with the remote control
Opening and closing with key in driver's door lock barrel
While the convertible top is moving, the key must be held in the "open" or "close" position in the lock barrel.
Auto-remote opening with remote control
While the convertible top is moving, the "Open" button on the remote control must be pressed and held.
Difference to opening with the button in the centre console switch cluster (SZM):
The side windows and rear window are lowered fully and are not raised again.
As there is no anti-trap circuit, convenience closing with the remote control is not possible.
Emergency closure of convertible top by hand
If the electro-hydraulic system should fail, the convertible top can also be closed manually.
Emergency closure runs as follows:
•
Fully lower all 4 side windows slightly and the rear window.
•
Release the convertible top compartment lid from inside the boot (left and right) and open the convertible
top compartment lid.
•
With the help of a second person, lift the convertible top out of the convertible top compartment and raise
the fins.
•
Close the convertible top compartment lid.
•
Lower the fins down onto the convertible top compartment lid.
•
Remove the cover panel in the middle of the bow strut.
•
Use the offset hexagon socket (from the on-board tool kit) at the bow strut to lock the convertible top. Here,
the hexagon socket is inserted into the drive for the cowl panel lock.
Lowering and raising the rear window
The convertible top module controls the automatic lowering and raising of the rear window (before and after the
convertible top is opened or closed).
The rear window can also be actuated by pressing the button above the switch block in the driver's door.
It is only possible to lower or raise the rear window under the following conditions:
•
Convertible top completely closed
•
Convertible top completely open
SBT Fully automatic convertible top E64
BMW AG - TIS
03.02.2013 19:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -