6 Series E64 650i (N62TU) CONVER
![background image](/bmw/6_Series_E64/650i_N62TU_CONVER/page-187004.png)
Note:
The mounting of the bearing bracket described later can only be
carried out if the inlet camshaft has not been axially displaced.
Special tools 11 9 472 and 11 9 475 prevent the inlet
camshaft from rotating and moving while the intermediate levers
are installed.
Fit special tool 11 9 472 and secure with special tool
11 9 475 .
Insert special tool 11 9 474 and initially tighten without play.
Note:
Removal of intermediate levers is described on 8th cylinder. The
same procedure is applicable to cylinders 5 to 7.
Raise one end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
Attach special tool 11 9 490 to end of torsion spring.
Support end of torsion spring protected with special tool
11 9 490 on inlet camshaft.
RA Removing and installing/replacing left intermediate levers (N62 from 9/03 and N6
BMW AG - TIS
05.02.2013 15:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -