6 Series E64 650i (N62TU) CONVER
12 61 280
Removing and installing/replacing oil
pressure switch (N62, N62TU)
Necessary preliminary tasks:
•
Switch off ignition
•
E65/E66 only: Remove intake filter housing
•
E53 only: Remove intake hood with air intake hose
Warning!
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Cylinder bank 1 to 4 on cylinder head, front right.
Engine oil may emerge when oil pressure switch is replaced; have
a cleaning cloth ready.
Release plug connector (1) and pull off.
Unscrew oil pressure switch (2).
Tightening torque 12 61 1AZ
.
Installation:
Check engine oil level, top up engine oil if necessary.
RA Removing and installing/replacing oil pressure switch (N62, N62TU)
BMW AG - TIS
05.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -