6 Series E64 650i (N62TU) CONVER
Detach plug (1) and unclip cable duct (2) from transmission
housing.
Tie wiring harness to one side.
Note:
Version 1
Grip clamping sleeve (1).
Slacken nut (2).
Detach retainer (3) towards bottom using a screwdriver.
Pull cable (4) out of holder.
Installation:
Adjust selector lever
Note:
Version 2
Unfasten nut.
Disconnect cable (1).
Installation:
Unfasten nut.
Adjust nut via cable (2) until spacing A=1 mm is obtained.
Tighten nut.
Supporting transmission:
Support transmission with special tools 23 4 050 , 23 0 132
and 00 2 030 .
Tasks are described in Transmission bracket.
RA Removing and installing automatic transmission (6HP26Z/ N62, N62TU)
BMW AG - TIS
05.02.2013 17:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
