6 Series E64 650i (N62TU) CONVER
54 34 300
Removing and installing/replacing rear
window
Necessary preliminary tasks:
•
Remove rear window module
•
Remove seal for rear window
Unfasten screws.
Tightening torque 54 34 10AZ
.
Slacken screws on left and right.
Tightening torque 54 34 11AZ
.
Disconnect left and right plug connections (2).
Installation:
Adjust right grub screw to dimension A in relation to Hall sensor.
A = 1 mm
Calibrating rear window:
Rear window must be moved downwards (signal from Hall sensor
- rear window at bottom).
This enables the convertible top module to determine the starting
travel of the rear window travel sensor.
RA Removing and installing/replacing rear window
BMW AG - TIS
05.02.2013 23:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
