7 Series E32 730i (M30) SAL
33 12 551
Replacing drive pinion with crown wheel
(Type G) - final drive removed -
Remove final drive,
refer to 33 10 010.
Secure final drive to assembly frame with special tool 33 1 070.
Drain off fluid. Take off case cover.
Installation:
Tightening torque,
refer to Technical Data 33 11 1AZ.
Top up oil level,
refer to Technical Data.
Remove complete final drive housing.
Caution!
Mark out bearing cover: do not confuse shims.
Remove lockplate.
Unfasten nut (1) and brace with special tool 23 0 020.
Remove input flange with special tool 33 1 150.
Specified friction torque is indicated on the new drive pinion
bearing and friction torque of old bearing does not have to be
measured.
RA Replacing drive pinion with crown wheel (Type G) - final drive removed -
BMW AG - TIS
25.01.2013 22:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -