7 Series E32 730iL (M60-1) SAL
13 62 511
Replacing temperature sensor for intake air
(M60, M62)
Switch off ignition.
Version 1:
(acoustic cover screwed down)
Remove seal caps (1) and unfasten nuts (2).
Remove acoustic cover.
Version 2:
(acoustic cover with press-stud fastener)
Open press-studs (1 ... 4) one at a time, at the same time lifting
the acoustic cover slightly. Once all four press-studs have been
opened, remove the acoustic cover.
Installation:
Position acoustic cover and press downwards until press-
studs (1 ... 4) click into place.
M60 and E31M62:
Temperature sensor is fitted in intake manifold:
Press down retaining spring.
Disconnect connector.
Unfasten temperature sensor.
Tightening torque,
refer to Technical Data 13 62 4AZ
Installation:
Interrogate fault memory of DME control unit, check faults in
memory then cancel fault memory.
RA Replacing temperature sensor for intake air (M60, M62)
BMW AG - TIS
02.02.2013 22:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
