7 Series E38 728i (M52) SAL
13 54 030
Removing and installing / sealing throttle
bodys (M52)
Removing mass air flow sensor,
refer to 13 62 560
Remove throttle body (ACS+T),
refer to 13 54 060
Disconnect cable (1).
Remove hoses for throttle valve preheating unit and seal (some
coolant will escape).
Unscrew bolts.
Remove throttle body and gasket.
Installation:
Replace seal.
Interrogate fault memory of DME-control unit, check faults in
memory then cancel fault memory.
Check coolant level and top up if necessary.
RA Removing and installing / sealing throttle bodys (M52)
BMW AG - TIS
26.01.2013 05:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -