7 Series E38 735iL (M62) SAL
Place oil container.
Unfasten banjo bolt (1) (inlet) and remove oil line.
Installation:
Replace sealing rings.
Tightening torque,
refer to Technical Data 24 31 4AZ.
Unfasten cap screw (2) (return) and pull off oil line.
Move both oil lines to the left side.
Installation:
Replace O-ring.
For Tightening torque,
refer to Technical Data 24 31 4AZ
Support transmission with special tool 00 2 030 / 24 5 301 /
24 0 250.
Unclip cable for oxygen sensors on transmission cross-member.
Unfasten screws and remove transmission crossmember.
Installation:
Tightening torque,
refer to Technical Data 24 71 1AZ.
RA Removing and installing automatic transmission (M62 with A5S 440Z)
BMW AG - TIS
08.02.2013 23:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -