7 Series E38 735iL (M62) SAL
41 00 ...
Installing a cavity bulkhead (expanded)
Note:
Carry over schematic representation to the relevant vehicle type.
The following repair represents the procedure for an already
expanded cavity bulkhead.
The cavity bulkhead remains on the body in this instance.
Before these work steps, prepare the new part so that it is ready to
install (adapting, cutting to size, applying welding primer etc.).
Clean contact surface (1) with spirit.
Apply an approx. 15 mm high bead (2) of original BMW window
adhesive to contact surface (1).
Fit, secure and weld up new part.
Warning:
Ensure adequate ventilation over entire processing period.
RA Installing a cavity bulkhead (expanded)
BMW AG - TIS
09.02.2013 02:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -