7 Series E38 740d (M67) SAL
11 12 505
Disassembling and assembling left cylinder
head (M67)
(cylinder head removed)
Loosen screws (1).
Remove pipe from exhaust gas recirculation (EGR) (2).
Installation:
Replace gasket.
Caution!
The glow plugs protrude at the sealing face and may be
damaged when the cylinder head is put down.
Remove glow plugs with special tool 11 6 050.
If necessary, drill out special tools 11 6 050 which were
delivered before 4/98 to
∅
9.5 mm 20 mm deep.
Installation:
Tightening Torque,
refer to Technical Data 12 23 2AZ.
Unfasten nut on exhaust manifold.
Remove exhaust manifold (1).
Installation:
- Replace gaskets.
- Apply a thin coat of copper paste to studs.
- Replace nuts.
- Tightening sequence from inside to outside!
RA Disassembling and assembling left cylinder head (M67)
BMW AG - TIS
10.02.2013 02:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
