7 Series E38 740d (M67) SAL
Install the more wear-resistant "S" conrod bearing shell (high
version) in the conrod.
Install pistons,
refer to 11 25 530.
Check connecting-rod bearing clearance:
Piston in BDC position.
Place special tool 00 2 590 (Plastigage model PG 1) on oil-free
crankshaft.
Place bearing caps in position, making sure that matching
numbers are paired.
Caution!
Do not turn the connecting rods or crankshaft.
Use the old connecting-rod bolts to check connecting-rod
clearance.
Tighten down conrod bolts with special tool 00 9 120 or special
tool 11 2 110.
Tightening torque,
refer to Technical Data 11 24 1AZ.
RA Replacing all conrod bearings (M67)
BMW AG - TIS
10.02.2013 02:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
